How to turn a shed into a traditional summer house
If the new year means a new shed, why not turn the old one into a traditional summer house?
You will need: 20mm clouts, bucket, clean water, craft knife, hammer, mineral turpentine, old shed (ours was cedar – previously painted exterior and unpainted interior), paintbrushes, Resene Lumbersider tinted to Resene Alabaster, Resene Lumbersider tinted to Resene Unwind, Resene Moss & Mould Killer, Resene Paint Prep and Housewash, Resene Quick Dry, Resene Walk-on flooring and paving paint tinted to Resene Inside Back, Resene Wood Primer, rubber gloves, saw, screwdriver, stiff-bristled brush, 2 x trellis panels.
To get the look: Mark painted the chair frames with Resene Lustacryl tinted to Resene Escape.
Handy tip: If you have opening windows and doors, use Resene Lustacryl waterborne enamel instead of Resene Lumbersider so doors and windows open and close without sticking.
Instructions
Step one Remove the old doors and hinges from the shed.
Step two Remove any builders’ paper from the walls with a craft knife and cut out two openings on either side wall of the shed, cutting between vertical supports, as shown.
Step three Fix the sections of trellis into each of the openings using 20mm clouts.
Step four
Step five Brush the solution onto the exterior painted surfaces of the shed and leave for 48 hours.
Step six 
Step seven Scrub the solution onto the exterior painted surfaces of the shed and rinse off with clean water. Allow to dry.
Step eight Apply two coats of Resene Unwind to the roof and door surrounds, allowing two hours for each coat to dry.
Step nineApply two coats of Resene Alabaster to the exterior walls, allowing two hours for each coat to dry.
Step tenApply one coat of Resene Wood Primer to the interior cedar walls and allow to dry. Clean brush in mineral turpentine.
Step eleven
Step twelve
Step thirteenApply two coats of Resene Alabaster to the exterior walls, allowing two hours for each coat to dry.
Step fourteenApply one coat of Resene Wood Primer to the interior cedar walls and allow to dry. Clean brush in mineral turpentine.
Step fifteen